How do you repair a break in the robotic lawnmowers boundary wire?
If you have the no loop signal message appear on your Automower or if you have the flashing blue light on the charging station then its likely that the perimeter boundary wire has been broken.
To join boundary wires:
1. Insert both cable ends into the coupler. Make sure the wires are fully inserted in the coupler by checking that the ends are visible through the transparent area on the opposite side of the coupler.
2.Now fully press down the button on top of the connector. Use a pair of pliers if the button on the coupler is difficult to press down by hand.
If the supplied boundary wire is not long enough to cover the entire working area, extra wire can be added using an original coupler. The total length of the boundary loop should however not exceed 800 meters.
IMPORTANT INFORMATION
Twisted cables, or screw terminal (chock-blocks), insulated with insulation tape are not satisfactory splices.
Soil moisture will cause the conductors to oxidize